Jumping Spider Enclosure

The Arachnamoria jumping spider enclosure made for jumping spiders from 8th instar to maturity.

This enclosure, crafted by me in collaboration with a small local laser cutting company, is specifically designed for jumping spiders from around the 8th instar to maturity. There is lots of space for your spider to roam and plenty of height to please their arboreal nature. Every enclosure includes a liner and a deep base for planting. Additionally, there is a hole with a sponge plug at the top for feeding, misting, and inserting probes from thermostats and hygrometers.

25cm tall 16cm wide 17cm Depth The enclosure is shipped flat pack to here are some helpful instructions to save on printer ink and paper.

Remove all of the protective film before construction.

Slot the three pegs of the base perpendicular into the three holes in the back and secure with the black bands.

Repeat the process with the top panel, connecting on the opposite side to the vents

Slot the small front panel, with the logo on, into the holes on the base. You may find it easier by laying the enclosure on its side as pictured.

Add the side with the ridges pointing towards the front of the enclosure and aligning the vents with those on the top panel. Secure all pegs into place, then repeat the process with the other side.

Gently ease the bottom pegs of the door into the two oval holes on either side of the enclosure to create a hinge, then pull the door up slot the door into the ridges to close.

The square sponge bung goes into the large opening in the top to seal cables into place and provide a feeding and misting hatch should you spider decide to web up the door. The plastic sheet is placed into the base to keep your substrate tidy and allow for the watering of plants Please remember the heat mat stands at the back behind the enclosure, not on the inside and not underneath. Add substrate, plants, cork bark, drift wood and magnetic décor anyway you like to create a unique home for your 8-legged little friend.